Automatic equipment for oar and retractable gates of global manufacturers nice, Roger Technology, doorhan availability Kiev, installation guarantee

Automation for Kiev sliding gates

Sliding gates are gaining popularity in both private and industrial sites. Therefore, the demand for sliding gate automation is constantly growing. Moreover, sliding gate automation is considered the simplest. The principle of operation is as follows: using a gear, a gear drive transmits torque to a gear rack. The toothed rack, in turn, is securely attached to the blade. That's the whole trick of this automation.

What automation functions are worth paying attention to.

Deceleration function.

Decreases the speed of sliding gate movement at the beginning and end of the gate closing/opening action, gaining a little more speed in the middle of the maneuver. The presence of this function reduces the load on the structure itself and on the sliding gate operator, reduces the noise level and creates additional safety.

Partial opening function.

This means that the automation allows you to open the gate for pedestrian movement in wicket mode. An excellent function, especially in cases where an additional wicket door was not installed.

Automatic closing function.

This is a kind of closing timer that allows you to close the sliding gate after a certain period of time, if you suddenly forgot to press the remote control button and close the gate.

Photocells of safety. This function allows you to immediately stop the gate if any obstacle enters their field of vision: a car, a person, an animal, etc., and change the direction of movement of the gate to the opposite.

Automation for sliding gates price Ukraine

Typically, a sliding gate automation kit includes:

electric drive with built-in control unit (with a radio receiver);

remote controls;

set of photocells;

signal lamp with antenna and other accessories.

What is important to know when choosing a sliding gate automation?

The choice of operator automation for sliding gates is quite diverse in terms of manufacturers and technical characteristics. What should be considered when studying the parameters of automation?

Weight and size of the gate. As you can imagine, the heavier the sash and the wider the opening, the more powerful the drive you will need.

The intensity of work allows you to calculate the maximum number of opening-closing cycles for a certain period of time: per hour, shift, day, etc. Those. if for domestic use 30% of the intensity is sufficient, then for industrial purposes a more powerful drive is needed.

Weather. In the winter season, automation, especially for sliding gates, often fails. The reason is low temperatures and precipitation, which stick to the guides, upper rollers and catchers. They create additional weight and practically "glue" the canvas to the ground. The actuator needs more effort to cope with the resistance and initiate movement of the structure. Therefore, we recommend choosing operators for doors with greater mechanical strength and increased torque.

Resistant to wind and wind conditions. If we are talking about a competent choice of automation, it is advisable to take into account the fact that when opening and closing the gate and the drive often have to overcome significant wind loads.

Roll-up fence

Sectional fencing

Fence netting in rolls

Mesh fence

Wickets and gates

Posts and fasteners

Protective mesh (fabric)

Egoza and barbed wire

Welded grid

Automation, barriers and bollards